Features

1. Passive PFC circuit.
2. High efficiency.
3. Low ripple & Noise.
4. Output over voltage protection.
5. Short circuit protection on all output.
6. Resettable power shut down.
7. Safety approved: CE,TUV, NEMKO, EMC.
8. 100% burn-in under high ambient temperature (50°C).
9. Vacuum-impregnated transformer.
10. MTBF: 100K hours at 25°C.
11. 100% Hi-pot tested.
12. Line input fuse protection.
     

Specifications
 
Input Specifications 

• Voltage:  230 VAC. 
• Frequency: 47Hz to 53Hz. 
• Input current:  5.0 amps maximum / 230 Vrms, 50 Hz. 
• Inrush curren: 90 amps cold, 110 amps warm measured at 264Vrms.

Output Specifications

• Over-voltage protection: +5V +3.3V +12V. 
• Remote ON/OFF control:  The Power supply shall accept a logic open collector level which will disable /enable all output.
• voltage (excluding +5V standby).
• Power good signal: turn-on delay 100ms to 500ms.

General Specifications 

• Efficiency: 65% min. 70% typical, at full load.
• Hold-up time: 10 mS minimum : 230 VAC.

Environmental Specifications 

• Temperature range: operating: 0°C~50°C.
• Storage: -20°C~+65°C.
• Humidity:   5~90% RH. 
• Dielectric withstand: input / output 1800VAC for1 second, input to frame ground 1800VAC for 1 second.

Output Voltage	Min. load	Max. load	Load Reg	Ripple & Noise
+5Vsb	0.0A	2.0A	±5%	60mV P-P
-5V	0.0A	0.3A	±10%	120mV P-P
-12V	0.0A	0.8A	±10%	150mV P-P
+12V	0.0A	13A	±5%	150mV P-P
+5V	2.0A	30/22.8A	±5%	60mV P-P
+3.3V	0.3A	9.0/20A	±5%	50mV P-P

Note: 
+3.3V & +5V total output not exceed 180W
+3.3V & +5V & +12V total output not exceed 280W